Read CIDR notation as a real range — network, broadcast, usable hosts and mask — and check whether an address falls inside it or two blocks overlap.
Waiting for a block
An address, a slash and a prefix length — `10.0.0.0/8`.
Waiting for a block
IPv4 and IPv6 are both handled.
CIDR Inspector runs entirely on your device — nothing is uploaded, and no host or network is contacted.
You’re on the Free plan. Compare plans
CIDR is a prefix length, and the mistake people make is treating the address in front of it as meaningful. `10.0.0.1/8` describes the same block as `10.0.0.0/8` — the host bits are ignored. This shows the network address it actually resolves to, so a rule written against the wrong one is visible rather than mysterious.
The range is shown as network address, broadcast address, first and last usable host, and a count. The two-address gap matters for small blocks: a `/30` has four addresses and two usable hosts, which is why point-to-point links use it and why a `/31` exists as a special case that uses both.
Overlap checking is the part that saves real time. Two security group rules, two route table entries, or a VPC and a subnet that quietly include each other produce behaviour nobody can explain from reading either rule alone.
IPv6 prefixes are handled with their real sizes, which are not quantities anyone should print in full. A `/64` holds more addresses than IPv4 has in total, and the tool says so in those terms rather than rendering a twenty-digit number nobody can read.
Nothing is contacted. This is arithmetic on the address, not a scan.
Yes. The prefix length decides the block and the host bits are ignored, so both describe 10.0.0.0–10.255.255.255. Writing the non-network form is legal and makes rules harder to read.
256 addresses, 254 usable. The first is the network address and the last is broadcast, neither of which can be assigned to a host.
Point-to-point links. RFC 3021 makes both addresses usable because there is no need for a broadcast address between exactly two endpoints — which is why it is the exception to the two-address rule.
It is a single address, which is how you write "exactly this host" in a place that expects a CIDR block — a firewall rule or a route. For IPv6 the equivalent is /128.
No. Nothing is contacted and no host is probed. It computes the range from the notation.